Chevrolet Camaro and Pontiac Firebird Driveshaft 1994-2001 V6 Replacement

Completely replace your factory two-piece 1994-2001 V6 Chevrolet Camaro driveshaft or V6 Pontiac Firebird driveshaft with a brand new single piece driveshaft

This single-piece driveshaft is a direct replacement for the original two-piece design. The installation of this replacement driveshaft requires no modification to the vehicle and can be installed by a qualified mechanic in less than a half hours time. The staff at Shaftmasters has sold 100’s of these replacement shafts and has not had one complaint or comeback. There is no need to be concerned that your V-6 Camaro/Firebird cannot function properly without a two-piece driveshaft. V-8 model Camaro/Firebirds operate with a factory OEM one-piece driveshaft and so can your V6. According to Dana corporation guidelines, a driveshaft can be manufactured to a specific length depending on the outside diameter of the tubing and the maximum r.p.m.'s it will operate at. These replacement shafts are 2.75” inch in diameter and at their operating length can be run at a maximum r.p.m. of 5000 before causing any concern.

Original two-piece driveshafts from the dealer cost at least $958. Our replacement driveshaft priced at $325.99 saves you considerable expense and in our opinion is a better driveshaft that will give much better service than the original design.

• Direct Bolt in replacement. No modifications necessary
• Eliminates OEM 2 piece design driveshaft that currently costs $958 at the dealer
• Money Back Guarantee
• 100’s of satisfied customers